![]() ![]() I would do some research because some motors need special running conditons like starting at high speed to start the flow of cooling water into the motor since the motor i am thinking about doesnt have a pump of any kind. You should replace the water impeller/rotor which ever this motor is equiped with. Reverse in mine is actualy turning the motor around 180 degrees around. My motor is direct drive no netural or reverse and it can be a challenge goin at a fast clip to manuver. Currently i have mine torn apart because my bearings or crank case seal is shot and it will stall any lower than the start position which is higher than low speed. ![]() If it has excesses play in the bearings and or low compression from rings and or the seal on the case bad it might not run low speed. They are 2 strokes and most important is looking at the bearings and how much side play as i am learning. First i would work on gettin the motor unstuck. They are all or the many i have seen very cold blooded and probilly will need some work. Keep in mind most of the motors now will be used parts and some nos. I give you a good hint i own a johnson seahorse td 20 out board and when it comes to boat it really does mean Bust OUT Another Thousand. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |